This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Start a New Discussion
Have Orbi RBK353 set up.
In Orbi set up, set MTU via WAN setup to 1492 and applied. All seems to be fine.
However if I check in CMD prompt : netsh interface ipv4 show subinterfaces
I get MTU as 1500 for Ethernet and WiFi. Not sure why.
Also, in Orbi, can I set different MTU values for WiFi and Ethernet?
Solved! Go to Solution.
No. MTU values are not needing any adjustments on the LAN side.
My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CAX30 Mode Mode | Wifi Router XR500 and RBK863 Router mode | Switches NG GS105/8, GS308v3, GS110MX and XS505M | Additional NG HW: C7800/CAX3/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX120v2, RAX50v2, XR450/500/700/1000, EX7500/EX7700
View solution in original post
MTU on Orbi is for the WAN side only. Check with your ISP to see what MTU value is needed if it's required by the ISP.
Thank you. So, is there a way to set the WiFi MTU in Orbi (via Command prompt say)?
@Wizzard370 wrote: Thank you. So, is there a way to set the WiFi MTU in Orbi (via Command prompt say)?
See page 39 of the user manual: https://www.downloads.netgear.com/files/GDC/RBK352/RBK352_RBK353_UM_EN.pdf
No command prompt needed.
• What is WiFi 7?
• Orbi WiFi 6E
• Orbi WiFi 6E Black Edition
• Orbi WiFi 6E Key Features
• What is Quad Band?
• What is the difference between WiFi 6E and WiFi 6?
• Do I need a WiFi 6E router to use WiFi 6E products?
