Orbi WiFi 7 RBE973

Re: RBR850/RBK852 intermittent connectivity


RBR850/RBK852 intermittent connectivity

I have essentially the same issue --- and it just started a few weeks ago. I have ruled out everything I can think of and simply cannot use Meet in home home network. Speeds are great, worked through every scenario and setting I could read about, have a good connection and speed, but the latency is awful. 


RBR850 -

RBS850 -

RBS850 -


I have had this setup for several years and never had an issue like this before. And, it happens on all devices. @pontooon did you ever figure it out? 

Message 1 of 2

Re: RBR850/RBK852 intermittent connectivity

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Be sure your using a good quality LAN cable between the modem and router. CAT6A STP is recommended. 



How many RBS are deployed? 
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR📡 and RBS🛰️ to begin with depending upon building materials when wired or wirelessly connected.
https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite ‌‌🛰


What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and 40 to 48 channel on 5Ghz.


Be sure to disable any MAC Address randomizers on phones and pads while at home:


Try disabling the following and see:
Armor, Smart Parental Controls or Circle, Traffic Meter.


Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.

Has a factory reset and setup from scratch been performed since last FW update? A complete pull of the power adapters for a period of time after the factory reset then walk thru the setup wizard and setup from scratch with a wired PC and web browser. https://kb.netgear.com/22697/How-do-I-install-my-NETGEAR-router-using-the-router-web-interface
Recommend setting the default DHCP IP address pool range to the following after applying and a factory reset: 192.168.#.100 to 192.168.#.200.
I would power OFF the ISP modem for 1 minute. Factory reset the router and power it off. Power ON the ISP modem and let it sync. Then power ON the router and walk thru the setup wizard again using a wired PC and a web browser.
Press the back reset button for 15 seconds then release. 



Might update FW as well at some point:




Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 0 kudos
  • 2 in conversation

Orbi WiFi 7