RBR850 with RBS850 Satellites (4)

[rimasidd]

Hello, I have RBR850 and (4) RBS850 .. 6500 Sq ft house

ATT -1 Gig fiber into the house

I am not using the router provided by ATT, I have created a bridge and use the Orbi as router.

The 1 Gig into the house and Orbi Router is fine, However I am lucky if I get 100MB within the separate rooms of the house on wifi

We also get intermitment outages / very slow speed (even in room where the satellite are in front of all devices) 

Any help would be appreciated. I have escalated to level 1 and its a finger pointing exercise vs. fixing the issue

Thanks

Rimasiddi

[FURRYe38]

What Firmware version is currently loaded?
Make sure the ISP modems wifi is fully disabled if the modem has wifi.

What is the distance between the router and satellite(s)? 30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected.

https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite

You can find other speed diagnosis steps in the community faq: https://community.netgear.com/t5/Orbi-AX/Community-FAQ-My-Orbi-speeds-are-slow-inconsistent-and-don-...

[rimasidd]

the fimrware is 3.2.18.1

I have the Large house layout per the diagram.. The router is on the second floor ( since that where my home wiring is )

the satellites are in 3 corners of the house.. 

[FURRYe38]

Didn't see any diagram attached to your post...

[rimasidd]

its a 2 story home (8000 Sq ft ) 

2 nd story

top right closets to home entrance - router / att modem 

top right furthest from home entrance - back of house - (Sat 1)

Top left furthest from Router- back of the house  ( Sat 2 ) 

  sat 1 and sat 2 ( extreme right / left back side of the house) 

first floor 

back right Sat 3

front left Sat 4

[FURRYe38]

What is the distance between the router and satellite(s)? 30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected.

A layout or drawing of where the system is placed would be more helpful so we can see where there located with in the home. 

[FURRYe38]

So by the looks you have RBS#4 right under the RBR...This would not be good.

[rimasidd]

it is.. I can change/ move that to the middle of hthe house as well 

thoughts?

[FURRYe38]

Yes. Around 30 feet is needed in between the RBR and any RBS and from RBS to RBS as well. 

[rimasidd]

ok will try that.. Any suggesstions for getting speed throughput .. I have a 1 GIG fiber line, and at this point the best room gets 300MB.. all the others get 100 MB