This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
I use my RBR350 in AP mode. The status LED is permanently red after boot up which I presume is because there is nothing connected to the WAN port. There doesn't appear to be any way to turn this LED off. I would have expected that the LED would always be off in AP mode since no connection to the WAN port is normal.
The status page shows internet connection is good. Is this a firmware "bug"?
In AP mode, you should have the wan port on the RBR350 connected to your router
Current setup: CM2000-> RBKE963B-> Trendnet TEG-S380-> GS716T-> pi-hole also in AP setup: RAXE500->EAX80 1.4gig download/50mbps upload from Xfinity We’re members of the public helping out on our own time.
In AP mode, you should have the wan port on the RBR350 connected to your router
Current setup: CM2000-> RBKE963B-> Trendnet TEG-S380-> GS716T-> pi-hole also in AP setup: RAXE500->EAX80 1.4gig download/50mbps upload from Xfinity We’re members of the public helping out on our own time.
Thanks for that. I hadn't realised that. I had thought that the WAN port was only for a modem connection. I switched it over and now the light is off and Internet is good. As a bonus i get an extra port on the RBR350.
Current setup: CM2000-> RBKE963B-> Trendnet TEG-S380-> GS716T-> pi-hole also in AP setup: RAXE500->EAX80 1.4gig download/50mbps upload from Xfinity We’re members of the public helping out on our own time.
