- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to locate my Orbi router in a room in the centre of my house so I can hardwire it with rj45 cables to my computer, Sonos and Hive heating hub located in that room (plus it’s the best place for the Orbi router to provide WiFi in the house) . This will allow the Orbi satellite to be placed in range in an outbuilding allowing WiFi coverage there and in the garden. My problem is my isp router is connected to the master socket located at the far end of my house furthest from the outbuilding so if I connect the orbi router directly with the supplied cat 5 rj45 cable it is too far away from the satellite for a stable connection between the two and it is impractical to run a very long rj45 cable from the modem to the intended position of the Orbi router. As a cheaper alternative to a second Orbi satellite I’m considering purchase a Netgear PLP-1000 1 port 1 Gigabit powerline adapter as an alternative to the normal hardwire connection between isp modem and Orbi router. Is this a feasible way of connecting them and if so will this adversely affect the connection speed/stability between the router and modem. Thank you.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks to both of you for your help and recommendations. I now feel a lot better about my next course of action.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
@Cheem wrote:
As a cheaper alternative to a second Orbi satellite I’m considering purchase a Netgear PLP-1000 1 port 1 Gigabit powerline adapter as an alternative to the normal hardwire connection between isp modem and Orbi router. Is this a feasible way of connecting them and ...
Yes. I do this without problems.
You don't say what your modem is. If it is a modem/router then you may want to put the Orbi into wireless access point mode.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
The model number is Sagem CS50001. If possible can you explain the difference/best option between using the Orbi in router versus access point mode with my described set up. I notice in AP mode that the ip adresses for all equipment is set by the modem (192.x.x.x) and router mode set by the Orbii (10.x.x.x) Thank you.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
Modem Combo Units:
This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
Thanks for the info/advice. Given that my plusnet hub modem/router firmware doesn’t support bridge mode I will set the Orbi to AP mode.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
You can try the modems DMZ if you want the Orbi in router mode.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
Now you know why I asked about the modem. It matters.
Unless you need fancy features, AP mode works fine with Orbi routers. It is common practice to use them in that mode, partly because the router bit is less capable than more "powerful" routers.
For example, parental controls and Armor won't work in AP mode.
If you want a more controllable system, then it might be easier to buy a basic modem only device than to faff around with complicated settings. For example, in the UK you can get the DM200 DSL modem for around £30. There are also inexpensive cable modems.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks to both of you for your help and recommendations. I now feel a lot better about my next course of action.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can a powerline adapter be used to connect an Orbi to my isp modem instead of a cat 6 rj45 cable
Hope it all works out. Good Luck.
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more