NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Ethernet backhaul not working?
Hi,
I’ve installed my Orbi system today, main device as Router.
Since the distance between the Router and the satellite is too far, I decided to use an ethernet backhaul.
Initially sync...
Hi,
where do I need to set the ip address resevation?
Did another try today, and again, ethernet backhaul is working fine when the satellite is connected to the router, but when i connect the satellite to the same switch to which the router had been connected, the same issue occurs....
so router and satellite work fine, but cannot be connected to using the web interface of te router or the app (only using remote management).
this is driving me mad....
the switch I use is a very simple Netgear G5608 8 port Gb switch.
when I cannot use the ethernet backhaul, the device becomes less usefull to me.
Regards,
Erwin
IP reservations are made on the router. Under Advanced/Setup/Lan Setup.
I have this same switch, accept the 5 port version, in the middle of my Orbi Satellite and router and wired back haul is working for me. Your problem maybe a cabling issue between the satellite, switch and router. You'll need to track this down. Do some close testing with the satelite and switch near the router, swapping in cabling and such to see where the issue is. Possible the switch could be a cause however I doubt it. Try different LAN ports and cabling.
Do you have in wall cabling? Mines all CAT6A. CAT6 patch cables from wall outliets and stuff.