NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi Router - QOS Setup
When I go to QOS setting, only see "Speedtest - powered by OOKxx", When I click the speedtest button, it will take a long time to run. After that, I go to Satellite to check "Connected Device", the ...
Your issue sounds like signal quality / strength?
It is not. I have 45db in both rooms due to the sattelite.
Yep, hmmm. I've got both old and new Foscams hooked up, no issues. Course each camera is different. So you think its the Orbi dropping the signal or communication?
I dont want to hijack this thread, so if I continue to see issues with my camera, I will make a separate post. After disconnecting/reconnecting my phone from the wifi, I can now ping and view my cameras... idk.
To stay on topic, Netgear, please fix the QoS page. I would like control over which devices get priority.
I was having a similar issue with the router freezing (looks like wifi dropping on some devices). I updated the firmware on both the router and satellite. Changed the wifi channels my router was operating on, disabled 20/40 coexistence mode, enabled beamforming, and enabled mu-mimo, some of which was at the direction of Netgear support. I haven't had issues since.