Possible set up RBK23 with Ethernet backhaul

---

brettich wrote:

---

---

I cannot find the interfaces / instructions on how to disable the wireless backhaul radios. I've spend the better part of the morning looking for them. Any ideas? I remember reading about it last week but can not find the post! 

---

To disable the backhaul, please follow the following steps:

1. From browser go to the router's debug page (http://192.168.1.1/debug.htm). Use your router's IP address or http://orbilogin.com/debug.htm
2. Enter admin as user name and your router’s management password
3. Tick "Enable Telnet" option
4. Use Telnet to connect to your Router telnet 192.168.1.1 and enter admin and the same password as above
5. Enter the commands: 

1. config set endis_wla_2nd_radio=0
2. config get wl5g_BACKHAUL_AP  --> printout should be usually ath2
3. ifconfig ath2 down --> ath2 is the output from the previous get command

The above is to disable the backhaul in the router. Please make sure that Daisy Chain is diabled so you will not have backhaul networks out of the satellites.

Good luck