Re: RBK30 backhaul problem

pioter · ‎2020-11-30

Hello Community,

I'm experiencing problems with connection between satellite and the router since new neighbours moved in. I've noticed their network running on 5 GHz channel 108 which interferes with the backhaul connection between the router and the satellite. Is it possible to change the channel for the backhaul communication?

Best regards

Peter

FURRYe38 · ‎2020-11-30

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

What is the size of your home? Sq Ft?
What is the distance between the router and satellite(s)? 30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected.
https://kb.netgear.com/31029/Where-should-I-place-my-Orbi-satellite

Also try turning down the power output of the RBRs wifi radios from 100% to 50% and see if this changes anything. Under Advanced Tab/Advanced Settings/Wireless Settings

Has a factory reset and setup from scratch been performed since last FW update?

My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CAX30 Mode Mode | Wifi Router RBK963 and RBK853 Router mode | Switches NG GS105/8, GS308v3, GS110MX and XS505M | Additional NG HW: C7800/CAX3/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, RAXE500, RAX120v2, RAX50v2, XR450/500/700/1000, EX7500/EX7700

CrimpOn · ‎2020-11-30

@pioter wrote:
Hello Community,
I'm experiencing problems with connection between satellite and the router since new neighbours moved in. I've noticed their network running on 5 GHz channel 108 which interferes with the backhaul connection between the router and the satellite. Is it

Would you mind sharing the country where this Orbi is located? The backhaul channel depends a lot on regulations regarding WiFi channels. My Orbi, for example, (in the US) uses channel 157 for the backhaul.

I love my Orbi.

pioter · ‎2020-12-01

My Orbi is located in Poland. Maybe due to some European Union regulations the backhaul connection is running on channel 108.

RBR40 is running firmware v2.5.1.16

RBW30 satellite is running firmware v2.5.0.2

My flat is around 753 sq ft. Due to large Wi-Fi noise from neighbours I used the satellite to boost my Wi-Fi. If there were no people around, then the room where the satellite is placed would be on the verge of 5 GHz range of RBR40.

The distance between the router and the satellite is approximately 30 ft, maybe slightly less than 30 ft.

I'm going to play with power output and update this post.

My service provider is UPC. It gave me Compal router, but I disabled it's Wi-Fi and it is running now in modem mode.

I haven't run factory reset and setup from scratch.