This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
RBR40 2.6.1.38 firmware manual upload | 400 Bad Request Error
My Orbi RBR40 is already on 2.6.1.36 but I see 2.6.1.38 is available on the Netgear support pages, even though not offered in the automatic update page in the router.
If I try to perform a manual update of the RBS-V2.6.1.38.img I get the message "400 Bad Request" a few seconds after the upload starts.
I tried different browsers on both a Mac and PC but always the same message. Rebooting the Orbi made no difference.
Using Firefox has the same response as using all the other browsers I tried. The RBW30 is already on the current released firmware and the RBK40 had the version 2.6.1.36 firmware installed manually without this error.
I am loathed to reset unless a simpler solution can be found. Maybe this is a bug of V2.6.1.36?
Using Firefox has the same response as using all the other browsers I tried. The RBW30 is already on the current released firmware and the RBK40 had the version 2.6.1.36 firmware installed manually without this error.
I am loathed to reset unless a simpler solution can be found. Maybe this is a bug of V2.6.1.36?
Using Firefox has the same response as using all the other browsers I tried. The RBW30 is already on the current released firmware and the RBK40 had the version 2.6.1.36 firmware installed manually without this error.
I am loathed to reset unless a simpler solution can be found. Maybe this is a bug of V2.6.1.36?
