NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR50 - CPU 100% then reboot after reboot
Ok, finally hopefully making progress....been doing a ton of reading. It looks like there are issues out there, but can't find a difinitive fix. I uploaded screen shoots of my CPU. I have ab...
Is Armor or Circle enabled?
Reboot the RBR and disconnect all devices accept for 1 wired PC. After the RBR is online. Check the cpu usage. Shouldn't be 100% after about 5 minutes of being online.
Has a factory reset been performed since last FW update?
Circle is not enabled and Armor (by mistake) has recently been enabled.
I have not done a factory reset since the last firmwear, I assume if I do that I will need to reconnect every connected device ? As I can't save any settings, is that accurate ?
Guess I am worried about the time it will take me to set everything back up.
Just as a side note, after turning off and back on - I stay low in the CPU range, like right now . Then for no reason it will max out and loose its mind.
| CPU Load | 23.5732% |
Try a factory reset and this time, don't setup Armor or enable it.
Seen Armor cause high CPU usage.I finally bit the bullet and did a factory reset (after recovering from some health issues)
I am back online, just curious if there are any key settings I should turn on or off now that I am in fresh factory mode ?
Been on for 5 min or so and this is my CPU Load
CPU Load 31.829% That did not last long
CPU Load 62.1951%