NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Replacing RBR40 with RBR50
Hello, I have had an RBR40 with three RBS20s for about a year now, in a 3200sf home. I have had recurring problems with both satellite disconnects and general loss of internet. It has gotten a bit ...
Thank you for the response, Furry. To answer your questions:
*I have a Netgear CM700 cable modem.
*My house is 3200sf/two storeys.
*Two satellites are about 30' from the router, the third is another 30' from the closest other satellite. I have daisy chain enabled.
*I see six neighbors' networks.
*Beamforming, MIMO and WMM were already on.
*I have not done a factory reset since the latest FW update. Is that recommended?
*I changed the 2.4ghz channel from Auto to 6. I changed the 5ghz to 40.
*I turned off 20/40 coexistence.
*I rebooted since making these changes. I'll see if the changes make any difference.
Thanks!
tgarvey wrote:Thank you for the response, Furry. To answer your questions:
*I have a Netgear CM700 cable modem.
*My house is 3200sf/two storeys. Is this a single or multi level home?
*Two satellites are about 30' from the router, the third is another 30' from the closest other satellite. I have daisy chain enabled.
*I see six neighbors' networks.
*Beamforming, MIMO and WMM were already on.
*I have not done a factory reset since the latest FW update. Is that recommended? Yes. See odd issues with users continuing to use the system after a FW update. Seems that a reset has resolved most of these kinds of oddities.
*I changed the 2.4ghz channel from Auto to 6. I changed the 5ghz to 40. Are these channels not being used by any neighbors?
*I turned off 20/40 coexistence.
*I rebooted since making these changes. I'll see if the changes make any difference.
Thanks!