Reply

RBK753S - One satellite shows blanks for both 'model name' and 'current firmware version' ???

njweb
Luminary

RBK753S - One satellite shows blanks for both 'model name' and 'current firmware version' ???

One of my two RBS753 satellites (show in red) is showing blanks (2nd and 4th columns in table below) for both 'model name' and current firmware version'. 

This issue was there with firmware 3.2.16.x and is sitll there with 3.2.18.x Smiley Sad

Not sure I can even safely assume that the "no new firmware available" display for that row  (Satellite 1) is accurate given that the 2 blank columns being displayed on that row...

 

Is anyone else experiencing this issue on your Admin page?

 

Table:

 

Status:
  Model Name Device Name Current Firmware Version Status
RouterRBR750RBR750V3.2.18.1No New Firmware Available
Satellite Orbi Satellite-1 No New Firmware Available
SatelliteRBS750Orbi Satellite-2V3.2.18.1Please wait a moment...
Message 1 of 2
FURRYe38
Guru

Re: RBK753S - One satellite shows blanks for both 'model name' and 'current firmware version' ???

https://community.netgear.com/t5/Orbi-AX/Orbi-RBK753S/m-p/2084691/highlight/true#M14406

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.3.5(Router mode/LAG Disabled) & EX7700x2
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK953(v6.0.3.68) & XR450(v130), RBK853 v4.6.3.16(AP) & RBK752 v4.6.5.14, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, and WNHDE111
Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 125 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 6E