Reply

Re: AP Mode and WLAN2: No acces to on-Premise mail server

Tscharser
Follower

AP Mode and WLAN2: No acces to on-Premise mail server

Hi,

We are using the Orbi system only for WLAN mesh with ethernet backhaul purpose and have a different gateway/modem.

 

The employee Wifi (Wifi 2) uses our internal DNS server, which resolves on-premise server systems such as Microsoft Exchange with their internal IP addresses (internal/external DNS split). As this Wifi does not permit LAN traffic, employees cannot access on-premise server systems.

How can we configure Orbi to use a different DNS server or apply fix address names for Wifi 2 only?

 

Kind regards

Martin

 

 

Model: RBR50|Orbi AC3000 Tri-band WiFi Router
Message 1 of 2
FURRYe38
Guru

Re: AP Mode and WLAN2: No acces to on-Premise mail server

What Firmware is currently loaded?
What is the Mfr and model# of the ISP modem or router the NG router is connected too?

 

If configured for AP mode then the Orbi wifi is just a traffic pass thourgh network. Orbi would not be inhibiting any kind of traffic when in AP mode. 

 

What is WiFi2? The SSID you set on Orbi? There hsould only be one SSID for the Orbi system. Anything else is handled by the main host router. 

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.2.1(LAG Disabled)>RBK853 v4.6.3.16(AP) & RBK752 v4.6.5.14
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, XR450(v120) and WNHDE111
Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 284 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 6E