- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
AP mode - add_nat_rule and del_nat_rule entries
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
AP mode - add_nat_rule and del_nat_rule entries
My Orbi RBK40 appears to have auto upgraded to 2.2.1.210 and now I am seeing repeated log entries that say:
[UPnP set event: del_nat_rule] from source 192.168.1.24, Thursday, October 11, 2018 11:49:33
[UPnP set event: add_nat_rule] from source 192.168.1.24, Thursday, October 11, 2018 11:49:32
The IP in question is assigned to my WD MyCloud NAS. I've never seen this before the upgrade and I have the Orbi in AP mode with a FiOS Actiontec router. Wondering whats going on?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Re: AP mode - add_nat_rule and del_nat_rule entries
Try a factory rest on the Orbi router and set up from scratch and configure AP mode again and see if the logs still appear with this...
My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CM1200 Modem | Wifi Router Orbi RBK752 (Router Mode), Wired Backhaul and R8500 with Orbi RBKE963 (AP Mode), | Switches NG GS105/8, GS308v3, GS110MX and XS505M |
Additional NG HW: C7800/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50, XR450, EX7500/EX7700
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Re: AP mode - add_nat_rule and del_nat_rule entries
FURRYe38 - I am reluctant to do that as my Orbi system is relatively stable. Any other thoughts?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Re: AP mode - add_nat_rule and del_nat_rule entries
Either run with it and don't worry abou the log messages or try a factory reset.
My Setup | ISP SparkLight | Internet Cable 1000↓/50↑ CM1200 Modem | Wifi Router Orbi RBK752 (Router Mode), Wired Backhaul and R8500 with Orbi RBKE963 (AP Mode), | Switches NG GS105/8, GS308v3, GS110MX and XS505M |
Additional NG HW: C7800/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50, XR450, EX7500/EX7700