Add Nighthawk x65 to an Orbi

[estroner]

I replaced a Nighthawk X65 with the Orbi 50 and was wondering if I could use the Nighthawk as a repeater/access point/bridge (not sure what to call it) to extend my signal into my attached garage? If so, could I do this wirelessly or do I need to run an Ethernet cable? 

[FURRYe38]

Do you mean EX6000? X65 ins't a valid model# 

[estroner]

Model number is R7960P

[FURRYe38]

You can use the R7960P in router, AP and wireless bridge only. 

[estroner]

Would the wireless bridge be what u am looking for? Just trying to extend the existing signal. Like I said, I am not familiar with all of the jargon. Thanks.

[FURRYe38]

No, the Bridge mode on the R7960P makes the router work like a wireless client device, thus it would connect to the wifi on the Orbi only, then you would wire connect LAN devices to the back of the R7960P. The R7960P doesn't have any repeating or extender functions. 

[estroner]

So try and sell it is what you are saying? Thanks

[FURRYe38]

NO. I didn't say that. You might keep it as a back up router, or you again could use it as a media bridge or 2ndary AP later on. I would hold on to it. Its a good router. I have one as well. 

[estroner]

Sounds good. Thanks for your help.

[FURRYe38]

Good Luck and Enjoy.