- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Need help on "bridge mode/access point" configuration
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
A music server I just purchased requires a wired connection to my LAN. Also, the user manual requires the following on the LAN: "Wireless Access Point or a Wireless router set to a "bridge mode/access point" configuration." So, when I had set up my 2-node ORBI just using the quick-start default settings, did it automatically configure it in either bridge mode or access point configuration? Or do I need to go into any admin menus and manually set it? If so, does making such a change affect any of the normal LAN connectivity for all the other typical computer and TV-type devices in my home?
Thanks in advance for your help!
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The default initial setup will be for Router Mode. You'll need to go into Advanced tab/Advanced settings/Router/AP mode. There you will see two modes, select AP mode. The system will reboot.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The default initial setup will be for Router Mode. You'll need to go into Advanced tab/Advanced settings/Router/AP mode. There you will see two modes, select AP mode. The system will reboot.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more