Reply
Highlighted
Luminary

Orbi RBR50 Armor panel not activated after reset V2.5.1.16

I updated firmware on my RBR50 and now have the dreaded Armor panel not activated despite the opposite being true. I need assistance to rectify this situation. Tried searching and looking in the Orbi app and Armor app. The only thing that I can  think would be a detriment is that I have my Netgear account and my routers' registration under two different emails. Am lost.

Message 1 of 2
Highlighted
Guru

Re: Orbi RBR50 Armor panel not activated after reset V2.5.1.16

Please post about this in the Armor app forum:
https://community.netgear.com/t5/NETGEAR-Armor/bd-p/en-home-armor
https://www.netgear.com/landings/armor
Good Luck.


@spewak wrote:

I updated firmware on my RBR50 and now have the dreaded Armor panel not activated despite the opposite being true. I need assistance to rectify this situation. Tried searching and looking in the Orbi app and Armor app. The only thing that I can  think would be a detriment is that I have my Netgear account and my routers' registration under two different emails. Am lost.


 


My Setup (Cable 900Mbps/50Mbps)>CAX80>XR450 v2.3.2.106(Router Mode)>RBK853 v3.2.11.2(AP Mode)
Additional NG HW: C7800/CM1100/CM1200/CM2000, Orbi CBK40, RBK853, R7800, R7960P,
EX7500/EX7700, XR450 and WNHDE111
Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 95 views
  • 0 kudos
  • 2 in conversation
Announcements