×

Introducing the Orbi 970 Series Mesh System with WiFi 7(BE) technology. For more information visit the NETGEAR Press Room.

Orbi WiFi 7 RBE973
Reply

Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

bbender716
Aspirant

Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

So I'm trying to assign a static IP for a raspberry pi. I originally assigned it using the IP Reservation panel and assigned, 192.168.1.97, rebooted, and then when I would connect the pi to the network, the network went down. I then read another thread where someone recommended changing the range to 192.168.1.100 - 192.168.1.200 so I changed the IP range to that.

 

Now the network comes up, but every time I try to load the Attached Device page it hangs, and if I try to change the IP range back to the original range, I get a:

 

"400 Bad Request

This server does not support the operation requested by your client."

 

Displayed. Any help would be appreciated!

Model: RBR50|Orbi AC3000 Tri-band WiFi Router
Message 1 of 4
SW_
Prodigy
Prodigy

Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

v2.5.0.38 was bad/pulled from NG support website.  The new attached device regconition feature has since been fixed in the latest firmware version 2.5.1.8.

Message 2 of 4
MCO79
Tutor

Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

Im on 2.5.1.8, doesn't work for me. I have a new thread going

Model: RBR50|Orbi AC3000 Tri-band WiFi Router
Message 3 of 4
FURRYe38
Guru

Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

https://community.netgear.com/t5/Orbi/RBR50-no-longer-showing-Detected-Devices/m-p/1868799/highlight...


@MCO79 wrote:

Im on 2.5.1.8, doesn't work for me. I have a new thread going


 

Message 4 of 4
Top Contributors
Discussion stats
  • 3 replies
  • 550 views
  • 0 kudos
  • 4 in conversation
Announcements

Orbi WiFi 7