Reply

Ports to be opened on firewall?

Erwin_S
Aspirant

Ports to be opened on firewall?

Hi,

 

I'm planning to hook my Orbi and ethernet backhaul to my Fortigate firewall which sits behind my cable modem.

Mode is set to bridge mode, without firewall, so no limits there.

 

I tried to find out which ports I should open on my firewall (both outgoing and incoming) so I can use the remote management functionality / app.

 

As far as I can see, no description is available in a document on the internet, so hopefully someone else can assist.

 

Regards,

 

Erwin

Model: RBK50| Orbi AC3000 High-Performance Tri-Band WiFi System
Message 1 of 2
FURRYe38
Guru

Re: Ports to be opened on firewall?

If you have a firewall in place before the orbi system, you may want to configure the Orbi for AP mode and not router mode. Not sure what ports are used by the app though...You might ask one of the forum moderators and see.

@DarrenM

 

My Setup (Cable 1Gbps/50Mbps)>CAX80 v2.1.2.1(LAG Disabled)>RBK853 v4.6.3.16
Additional NG HW: C7800/CM1100/CM1200CM2000, Orbi CBK40, CBR750, RBK50(v22), SXR30(v110), R7000(v34), R7800(v84), R7960P(v82), EX7500/EX7700, XR450(v120) and WNHDE111
Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 1050 views
  • 0 kudos
  • 2 in conversation
Announcements