Reply

Re: RBK753S in AP Mode

CDELL801
Aspirant

RBK753S in AP Mode

Just installed my Firewalla Purple, set my Orbi  RBK753S in AP mode and it looks like all of the wireless  connections are just going to the main  RBR750 and none of the   satellites have any  wireless connections to them anymore, they do show online and good connection and when looking at the network map in the app, the wirless devices now far away from the main router have a poor signal, is this normal in AP mode?  Are the  satellite's  now only good for wired connections?   Firmware Version V4.6.5.14_2.0.54

Message 1 of 5

Accepted Solutions
CDELL801
Aspirant

Re: RBK753S in AP Mode


@CrimpOn wrote:

Changing from router mode to access point (AP) mode causes the entire Orbi system to reboot.  This might be a case of lots of frantic devices saying, "Where did my WiFi go?...... Oh, THERE it is." and connecting to the router because it is the first unit to begin broadcasting the WiFi SSID.

 

It might be interesting to power cycle some of those devices that 'should' be connecting to a satellite and see where they connect.


 

I have tried that,  but I have not rebooted all of the orbi's since I setup the Firewalla Purple.  Maybe I will reboot them and then try the devices again, but should they show up under the satellites connected devices? 

View solution in original post

Message 3 of 5

All Replies
CrimpOn
Guru

Re: RBK753S in AP Mode

Changing from router mode to access point (AP) mode causes the entire Orbi system to reboot.  This might be a case of lots of frantic devices saying, "Where did my WiFi go?...... Oh, THERE it is." and connecting to the router because it is the first unit to begin broadcasting the WiFi SSID.

 

It might be interesting to power cycle some of those devices that 'should' be connecting to a satellite and see where they connect.

I love my Orbi.
Message 2 of 5
CDELL801
Aspirant

Re: RBK753S in AP Mode


@CrimpOn wrote:

Changing from router mode to access point (AP) mode causes the entire Orbi system to reboot.  This might be a case of lots of frantic devices saying, "Where did my WiFi go?...... Oh, THERE it is." and connecting to the router because it is the first unit to begin broadcasting the WiFi SSID.

 

It might be interesting to power cycle some of those devices that 'should' be connecting to a satellite and see where they connect.


 

I have tried that,  but I have not rebooted all of the orbi's since I setup the Firewalla Purple.  Maybe I will reboot them and then try the devices again, but should they show up under the satellites connected devices? 

Message 3 of 5
FURRYe38
Guru

Re: RBK753S in AP Mode

For your future needs, Netgear has set up a community forum specifically for the Orbi AX (WiFi 6) products. Most of the people who watch that forum are more likely to have experience with Orbi AX and know how to work it better than those of us who follow this "general Orbi" forum. Might be more likely to find someone who has a solution if the question is posted there:
https://community.netgear.com/t5/Orbi-AX/bd-p/en-home-orbi-ax


Please use this link to the main forum product list to review and choose where to make your posts. 
https://community.netgear.com/t5/NETGEAR-Forum/ct-p/en-netgear


Thank you

My Setup ISP SparkLight | Internet Cable 1000↓/50↑ CAX80 Modem Mode |  Wifi Router RBK953 (Router Mode) 2.5Gb Wired Backhaul | Switches NG GS105/8, GS308v3, GS110MX and XS505M XR1000 (Router Mode) RBK853 AP Mode  | 

Additional NG HW: C7800/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50, XR450, EX7500/EX7700

Message 4 of 5
CDELL801
Aspirant

Re: RBK753S in AP Mode

Good call on the reboot, I rebooted  Orbi and then things started to attact to the  satellites over wifi again.

 

 

Message 5 of 5
Top Contributors
Discussion stats
  • 4 replies
  • 830 views
  • 2 kudos
  • 3 in conversation
Announcements

Orbi WiFi 6E