RBR50 generating resolving hosts error

[rob9999]

I have 1 RBR50 and 3 RBS50 units.

Often (> 50%) I an receiving a 'resolving hosts' error on my computer.  I find that I am connected to the nearest RBS50 with a stong signal.   I then connect to the RBR50 using 192.168.1.1 with no problem.  That would seem to elliminate the RBS50 as the issue.

The status shows that the internet connection is ok.  If I reboot the router, the connection will be ok for a period of time then it will happen again.  

Please help.  Any suggestions?

[FURRYe38]

What FW version are you using?

Have you set up any reserved IP addresses ON the router for your PCs and devices?

[rob9999]

The firmware level is V2.1.2.18

I have no reserved addresses.  I know networking and this is baffling.

[FURRYe38]

Try the new v2.1.3.4. Do a factory reset on both router and Satellites then set up from scratch. Skip setting up the Satellites.

I would also do a IPCONFIG /release, then /renew then /flushdns on your PCs. Reboot reset of mobile devices AFTER you have set up the router.

Test. Then set up the Satellites.

[lindsay_s_Chi]

Did you find a solution? I am having the same problem (Resolving Host error...)

[FURRYe38]

What model Orbi system do you have?

What FW version are you using?

Have you set up any reserved IP addresses ON the router for your PCs and devices?

---

@lindsay_s_Chi wrote:

Did you find a solution? I am having the same problem (Resolving Host error...)

---