Reply

RBR50 - satellites show as disconnected, but devices are connected to them?

mrbofus
Aspirant

RBR50 - satellites show as disconnected, but devices are connected to them?

As shown in the screenshot below, the admin interface is showing that two of my satellites are disconnected.  However, right below that, it shows that two of my devices are connected to those "disconnected" satellites.  How are the devices connected to disconnected satellites?

 

Screen Shot 2020-11-22 at 20.00.29.png

Model: RBR50|Orbi AC3000 Tri-band WiFi Router
Message 1 of 2
FURRYe38
Guru

Re: RBR50 - satellites show as disconnected, but devices are connected to them?

Has a factory reset and setup from scratch been performed since last FW update? 


What is the distance between the router and satellite(s)? 30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected.

 

I would updated to v40 or downgrade back to v16

https://community.netgear.com/t5/Orbi/RBR50-RBS50-Firmware-Version-2-6-1-40/m-p/1997895/highlight/tr...

 

 

 

 

My Setup ISP SparkLight | Internet Cable 1000↓/50↑ CAX80 Modem Mode |  Wifi Router RBK953 (Router Mode) 2.5Gb Wired Backhaul | Switches NG GS105/8, GS308v3, GS110MX and XS505M | XR1000 (Router Mode) and RBK853 AP Mode  | 

Additional NG HW: C7800/CAX80/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: MK63, R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50, XR450, EX7500/EX7700

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 146 views
  • 0 kudos
  • 2 in conversation
Announcements

Orbi WiFi 6E