Reply

RBS20 Power Flashing Red

JAKPhoto
Follower

RBS20 Power Flashing Red

My RBS20 power is flashing red. The light on top is pulsing white. This happened after the last firmware update. I’ve tried to factory reset the unit numerous times with a paper clip holding down for 30 seconds. I tried the 30/30/30 reset too. I tried a different power adapter.
Any suggestions?
Message 1 of 3
antinode
Guru

Re: RBS20 Power Flashing Red

> My RBS20 power is flashing red. [...]


      https://community.netgear.com/t5/x/x/m-p/2122679

Message 2 of 3
FURRYe38
Guru

Re: RBS20 Power Flashing Red

https://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTP
Need to press the reset button for 30 seconds then release, then it send to PUT the command and upload the FW. 
I had a problem on a Windows 10 PC where this didn't work to use TFTP, so I switched to a WIndows 7 PC and the TFTP worked.


Try nmrpflash?
https://github.com/jclehner/nmrpflash


@JAKPhoto wrote:
My RBS20 power is flashing red. The light on top is pulsing white. This happened after the last firmware update. I’ve tried to factory reset the unit numerous times with a paper clip holding down for 30 seconds. I tried the 30/30/30 reset too. I tried a different power adapter.
Any suggestions?



My Setup ISP SparkLight | Internet Cable 1000↓/50↑ CM2000 Modem | Wifi Router RAXE50 and R8500(v.158) Router Mode and RBK752(v.2) AP mode | Switches NG GS105/8 | 

Additional NG HW: C7800/CM1100/CM1200/CM2000, Orbi: CBK40, CBK752, RBK50, RBK853, RBK752, RBK953, SXK30 | NightHawk: R7000, R7800, R7960P, R8000, R8500, RAXE500, RAX50, XR450, EX7500/EX7700, GS308v3

Message 3 of 3
Top Contributors
Discussion stats
  • 2 replies
  • 258 views
  • 0 kudos
  • 3 in conversation
Announcements

Orbi WiFi 6E