- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Wired and wireless keeps dropping
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Wired and wireless keeps dropping
I keep getting intermittent network drops with WiFi and wired. I just checked the logs and got this:
DoS Attack: ACK Scan] from source: 23.246.6.184, port 443, Sunday, March 15, 2020 21:32:04
[DoS Attack: ACK Scan] from source: 209.148.215.67, port 443, Sunday, March 15, 2020 21:31:40
[DoS Attack: SYN/ACK Scan] from source: 13.225.198.74, port 443, Sunday, March 15, 2020 21:31:34
[DoS Attack: SYN/ACK Scan] from source: 17.248.135.243, port 443, Sunday, March 15, 2020 21:31:27
[DoS Attack: SYN/ACK Scan] from source: 17.248.135.80, port 443, Sunday, March 15, 2020 21:31:27
[DoS Attack: SYN/ACK Scan] from source: 17.248.135.119, port 443, Sunday, March 15, 2020 21:31:27
[DoS Attack: SYN/ACK Scan] from source: 17.248.135.16, port 443, Sunday, March 15, 2020 21:31:27
[DoS Attack: SYN/ACK Scan] from source: 17.248.135.110, port 443, Sunday, March 15, 2020 21:31:27
[DoS Attack: SYN/ACK Scan] from source: 17.248.187.199, port 443, Sunday, March 15, 2020 21:31:27
23.246.6.184 for example seems to be Netflix which is being used right now.
I use Orbi with a Rogers Hiltron Modem which is connected via WAN port. I have also included a screen shot of my statics.
Any Ideas
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
What Firmware is currently loaded?
What is the model# of the ISP modem the NG router is connected too?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
Rogers Internet , hitron modem-CODA 4582
(In bridged mode)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
another case for Orbi 2.5.1.8.....bad FW
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).
Has a factory reset and setup from scratch been performed since last FW update?
Above suggestions working:
https://community.netgear.com/t5/Orbi/Throttling-Devices-RBK53/m-p/1858561/highlight/true#M81925
@colinha667 wrote:
Orbi 2.5.1.8
Rogers Internet , hitron modem-CODA 4582
(In bridged mode)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
@FURRYe38 wrote:What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).
Has a factory reset and setup from scratch been performed since last FW update?
Above suggestions working:
https://community.netgear.com/t5/Orbi/Throttling-Devices-RBK53/m-p/1858561/highlight/true#M81925
@colinha667 wrote:
Orbi 2.5.1.8
Rogers Internet , hitron modem-CODA 4582
(In bridged mode)
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
This is occurring with wired (RJ45) as well. I have noticed this started to occur after the latest firmware update.
I have not tried a factory wipe yet.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
@colinha667 wrote:
I’ve actually noticed this started occurring after the firmware upgrade!
revert back to the previous FW
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
Try a reset and setup from scratch.
@colinha667 wrote:
The distance is good between the router and sat
This is occurring with wired (RJ45) as well. I have noticed this started to occur after the latest firmware update.
I have not tried a factory wipe yet.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Wired and wireless keeps dropping
@FURRYe38 wrote:Try a reset and setup from scratch.
@colinha667 wrote:
The distance is good between the router and sat
This is occurring with wired (RJ45) as well. I have noticed this started to occur after the latest firmware update.
I have not tried a factory wipe yet.
and stay away from 2.5.1.8
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more