× NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Orbi WiFi 7 RBE973

Blocking IP range/subnet with ACL

RussU
Aspirant

Blocking IP range/subnet with ACL

I can only assume I'm missing something here... I want to block access to one VLAN from another whilst maintaining routing via the switch. Simple enough on the face of it.

 

I have set an IP ACL bound to the VLAN in question to block IP traffic to 192.168.0.0 255.255.255.0 but it does nothing. If I set the IP to 192.168.0.10 255.255.255.0 then I cannot ping the device on that IP, so the rest of my config should be fine.

 

Am I doing something wrong, or is this just not supported on this switch?

 

Firmware is updated to 6.3.1.11

Model: GS716Tv3|ProSafe 16 ports Gigabit Smart switch,GS724Tv4|ProSafe 24 ports Gigabit Smart switch,GS748Tv5|ProSafe 48 ports Gigabit Smart switch
Message 1 of 4

Accepted Solutions
DaneA
NETGEAR Employee Retired

Re: Blocking IP range/subnet with ACL

Hi RussU,

 

Welcome to the community! 🙂

 

Kindly check this link as a reference guide in setting up ACL.

 

 

Regards,

 

DaneA

NETGEAR Community Team

View solution in original post

Message 2 of 4

All Replies
DaneA
NETGEAR Employee Retired

Re: Blocking IP range/subnet with ACL

Hi RussU,

 

Welcome to the community! 🙂

 

Kindly check this link as a reference guide in setting up ACL.

 

 

Regards,

 

DaneA

NETGEAR Community Team

Message 2 of 4
RussU
Aspirant

Re: Blocking IP range/subnet with ACL

That helped, thanks. Wildcard netmask is needed, should have read the manual!
Message 3 of 4
DaneA
NETGEAR Employee Retired

Re: Blocking IP range/subnet with ACL

Hi RussU,

 

You're welcome! 🙂  I am glad that it helped you.

 

Feel free to post your future concerns here in the community.

 

 

Regards,

 

DaneA

NETGEAR Community Team

Message 4 of 4
Top Contributors
Discussion stats
  • 3 replies
  • 6085 views
  • 1 kudo
  • 2 in conversation
Announcements