Blocking IP range/subnet with ACL

[RussU]

I can only assume I'm missing something here... I want to block access to one VLAN from another whilst maintaining routing via the switch. Simple enough on the face of it.

I have set an IP ACL bound to the VLAN in question to block IP traffic to 192.168.0.0 255.255.255.0 but it does nothing. If I set the IP to 192.168.0.10 255.255.255.0 then I cannot ping the device on that IP, so the rest of my config should be fine.

Am I doing something wrong, or is this just not supported on this switch?

Firmware is updated to 6.3.1.11

[DaneA · Accepted solution]

Hi RussU,

Welcome to the community! 🙂

Kindly check this link as a reference guide in setting up ACL.

Regards,

DaneA

NETGEAR Community Team

[DaneA · Accepted solution]

Hi RussU,

Welcome to the community! 🙂

Kindly check this link as a reference guide in setting up ACL.

Regards,

DaneA

NETGEAR Community Team

[RussU]

That helped, thanks. Wildcard netmask is needed, should have read the manual!

[DaneA]

Hi RussU,

You're welcome! 🙂  I am glad that it helped you.

Feel free to post your future concerns here in the community.

Regards,

DaneA

NETGEAR Community Team