- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Cannot get MAC ACL to work
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cannot get MAC ACL to work
Have a stack of 5, and trying to lock down 1 port to 1 MAC address. Followed the documentation and all that stuff. I can get it to block all traffic, but that's about it. The ACL rules seem weird to me. Even though I have tried pretty much every combination, this makes the most sense to me:
ACL based on source MAC
Action - permit - match every (false) - destination MAC (MAC of the allowed device) - MAC Mask (FF:FF:FF:FF:FF:FF)
Direction - Inbound
Bind to the appropriate port
I have also tried adding a deny - match every (true) rule after the permit rule. Tried changing source/destination, etc. I spent about 3 hours banging on it and could never get it to work properly.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cannot get MAC ACL to work
Welcome to the community! 🙂
Kindly check the KB article below and use it as your guide:
For further technical assistance, kindly open a chat or online a support ticket with NETGEAR Support here at anytime.
Regards,
DaneA
NETGEAR Community Team