Reply

Re: Change MTU size on XS728T

Retired_Member
Not applicable

Change MTU size on XS728T

The manual says I can change the MTU size, but I dont see (in the GUI) the setting to change at Switching > Ports > Port Configuration.

 

Model Name XS728T Boot Version 1.0.0.0 Software Version 6.5.1.30

Message 1 of 2

Accepted Solutions
ElaineP
NETGEAR Expert

Re: Change MTU size on XS728T

Hi gcarson,

 

Welcome to NETGEAR community!

 

The L2 Jumbo Frames size cannot be changed for XS728T, which default value should be 10240 byte frame size under Switching.

 

But the L3 ipv4 MTU can be changed under Routing>IP>IP Configuration, the default value is 1500.

 

Regards,

NETGEAR Employee

View solution in original post

Message 2 of 2

All Replies
ElaineP
NETGEAR Expert

Re: Change MTU size on XS728T

Hi gcarson,

 

Welcome to NETGEAR community!

 

The L2 Jumbo Frames size cannot be changed for XS728T, which default value should be 10240 byte frame size under Switching.

 

But the L3 ipv4 MTU can be changed under Routing>IP>IP Configuration, the default value is 1500.

 

Regards,

NETGEAR Employee

Message 2 of 2
Top Contributors
Discussion stats
  • 1 reply
  • 7406 views
  • 1 kudo
  • 2 in conversation
Announcements