Connecting GS752TPP and GS728TPv2

[mtuma5672]

I have the switches connected through ports 48 and  23 respectively.  The new switch  (GS728TPv2) initially had a DHCP address.  I configured the switch for  a static address.  I configured the VLANs for  each port on both switches.  I am not getting any traffic between the two (not even ping). What am I missing? 

[mtuma5672 · Accepted solution]

DaneA,

I figured out what the issue was. I needed to tag ALL of the VLANs on the trunk ports.

Thanks,

Mike

[DaneA]

@mtuma5672,

Welcome to the community! 🙂

It would be best if you post a diagram of your detailed network setup.  

Let me share the article below and use it as your guide:

How do I setup a VLAN trunk link between two NETGEAR switches?

Regards,

DaneA

NETGEAR Community Team

[mtuma5672 · Accepted solution]

DaneA,

I figured out what the issue was. I needed to tag ALL of the VLANs on the trunk ports.

Thanks,

Mike