Firmware Update Problem Gs748TS

[robby61]

Hello everybody,
I can not run a firmware update because the static IP address can not enter.
When I wear these in the form of a 192.168.xxx.xxx, is to apply this reset to 0.1.134.160.
If I go through a factory reset, is initially the 192.168.0.239, try the update this but deleted and entered the 0.1.134.160.
This cancels the Smartwizzard and discover shows no device.
Who can help me ?
Thank you

[robby61 · Accepted solution]

Hello ,

the problem is settled.
Have solved it with a TFTP server.
You only have to put the firmware file into a folder alone.
Thank you all
Best regards
Robby

[DaneA]

Hi robby61,

A few questions:

a. Have you tried to update the firmware by accessing the web-GUI of the GS748TS and not using the SmartWizard?

b. What is the current firmware version of the GS748TS?

c. To what firmware version are you trying to upgrade the GS748TS?

Regards,

DaneA

Netgear Community Team

[robby61]

Hello,

 I uploaded the new bootloader with TFTP Server.
Only the firmware it does not accept.

The old version Booloader  was 1.0.0.07; new 1.0.2.0 , this ist no theme more

current firmware version of the GS748TS is 3.1.0.1,

upgrade the first 5.0.21 to

the next  5.2.11

The problem is that the switch does not recognize smart Wizzard.

Even the smart control center does not recognize him.
The web access works.

factory reset no success

Reset the device with needle.

[robby61 · Accepted solution]

Hello ,

the problem is settled.
Have solved it with a TFTP server.
You only have to put the firmware file into a folder alone.
Thank you all
Best regards
Robby