× NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Orbi WiFi 7 RBE973
Reply

GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and stuck with old firmware

cat139lyleb
Aspirant

GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and stuck with old firmware

GS108Tv3 did not take an update, so does anyone has the same problem?

 

I already rebooted and tried the update repeatedly, but it seems it stuck with 7.0.7.1, so please help!

 

Thanks!

Message 1 of 6
schumaku
Guru

Re: GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and st

The switches have two firmware images on board. Have selected the correct image to become active after the reboot?
Message 2 of 6
cat139lyleb
Aspirant

Re: GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and st

Did that too, same result...
Message 3 of 6
schumaku
Guru

Re: GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and st

What is show on

1. Configure dual image settings on (user manual page 447), and
2 The dual image status (user manual page 449)?
Message 4 of 6
cat139lyleb
Aspirant

Re: GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and st

Where the manual book or something? Also how do I suppose to do with 2 ways firmwares updates, I thought it should be simple to do as same as what routers do...

Message 5 of 6
schumaku
Guru

Re: GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and st


@cat139lyleb wrote:

Where the manual book or something?


There is one way for the firmware update. However there are two firmware images in place, which can be maintained individually. You as the switch admin define which image will be activated following the installation, or which image you want to have loaded following a reboot or cold start. Can't take away your learning curve.

 

https://www.netgear.com/support/product/gs108Tv3.aspx 

https://www.netgear.com/support/product/gs108Tv3.aspx#docs 

 

@cat139lyleb wrote:

I thought it should be simple to do as same as what routers do...


It's not that straight forward I'm afraid.

Message 6 of 6
Top Contributors
Discussion stats
  • 5 replies
  • 799 views
  • 0 kudos
  • 2 in conversation
Announcements