Introducing the Orbi 970 Series Mesh System with WiFi 7 technology. For more information visit the NETGEAR Press Room.
This topic has been closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Start a New Discussion
Hello
Im very green with networking and could use some tips to enabling SNMP on GS110TUP.
Actually i thought SNMP was enabled by default, but when i try to send an SNMP command from linux i get following:
snmpwalk -v1 -c public 192.168.123.22
Timeout: No Response from 192.168.123.22
So i thought, ok, maybe its not enabled, but when i follow the manual on how to enable it it gives me an error.
system - SNMP - SNMP V1/V2 - Community configuration
Management Station ip 0.0.0.0 - Management Station IP Mask 0.0.0.0 - Community string public - Acess Mode ReadOnly - Status Enable
when i then click add i get get error message "Error: Default public and private community strings are not allowed"
Any ideas?
or am i comepletely off?
You need to change both the names for read (default: public) and write (default. private) to something more "secure" - that's all.
