- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: GS308T LACP Setup problem with TrueNas Server
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone ,
I try to settings up the LACP protocol with my TrueNas Computer .
After I configured all port as should be , no networking connection between GS308T to TrueNas .
Model Name - GS308T
Boot Version - 1.0.0.1
Software Version - 1.0.5.6
All settings for LACP side of GS308T upload here inside pdf file.
The GS308T working perfectly beside the LACP feature .
I will want to tag (Untagged) port 7/8 to VLAN40 at my house .
I try to figure it out , where is my mistake in term of settings LACP feature .
Appreciate any help or suggestion thanks a lot .
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community!
Could you also provide the LACP configuration for the TrueNAS? Also, please verify if the LACP configuration on the TrueNAS has the same hash mode as the switch.
Under PVID Configuration on the switch, please click on LAG and see if AsrockNas1 has PVID40.
Regards,
JeraldM
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome to the community!
Could you also provide the LACP configuration for the TrueNAS? Also, please verify if the LACP configuration on the TrueNAS has the same hash mode as the switch.
Under PVID Configuration on the switch, please click on LAG and see if AsrockNas1 has PVID40.
Regards,
JeraldM
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GS308T LACP Setup problem with TrueNas Server
Thanks for the response .
I succeeded to setup the LACP as should on VLAN40, you point at the right spot 🙂