- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GS728TPv2 Forbidden VLANs
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
we using 8 of the GS728TPv2 switchws. All of them are allready configured but on 2 switches we have to define forbidden VLANs on some ports. How can I do this over the Web-GUI?
Regards,
Piet
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @DanskePiet,
Welcome to the community! 🙂
I inquired your concern to the higher tier of NETGEAR Support and got a feedback today. As per the higher tier of NETGEAR Support, the purpose of Forbidden VLANs is to prevent ports joining a VLAN when ports can be dynamically added using a protocol like GVRP. There is a Remove All option, where ports that were dynamically registered through GVRP are removed from the VLAN. Kindly check page 129 of the GS728TPv2 user manual here.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @DanskePiet,
Welcome to the community! 🙂
I inquired your concern to the higher tier of NETGEAR Support and got a feedback today. As per the higher tier of NETGEAR Support, the purpose of Forbidden VLANs is to prevent ports joining a VLAN when ports can be dynamically added using a protocol like GVRP. There is a Remove All option, where ports that were dynamically registered through GVRP are removed from the VLAN. Kindly check page 129 of the GS728TPv2 user manual here.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GS728TPv2 Forbidden VLANs
Hi Dane
Thanks for the replay to my question! This answer my question.