- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: How to delete LAGG/LACP configuration?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We've been using a 6-port 10GbE LACP LAGG between our FreeNAS NAS and the XS728T in our post yltra hi-def production/editing studio. We handle mostly 2K/4K/6K film production
Anyway, most of the time it has worked well. But, there is occasional severe bandwidth variances and dropoffs that aren't acceptable in film production. So, we've decided to go back to a simple setup od 6 invidually configured NIC ports, each with it's own small sub-domain(10.0.1.x, 10.0.2.x, 10.0.3.x, etc). We'll assign a 2-3 of workstations to each port/sub-domain and see if that stabilizes bandwidth.
Unfortunately, I cannot figure out how to delete the existing LAG,. It's 2AM, so maybe it's just fatigue
Any help greatly appreciated
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Victor-R,
Welcome to the community! 🙂
I do not have an XS728T switch to test your concern. However, I think you will just have to uncheck the ports that you have included in the LAG you have created.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Victor-R,
Welcome to the community! 🙂
I do not have an XS728T switch to test your concern. However, I think you will just have to uncheck the ports that you have included in the LAG you have created.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: How to delete LAGG/LACP configuration?
Thank you!
I thought that was how it worked, but was unsure because the User Guide makes no mention of removing LAGGs
My biggest concern was that I woud be unable to reassign those ports for VLAN routing after unchecking
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: How to delete LAGG/LACP configuration?
Hi Victor-R,
You're welcome! 🙂
Feel free to post your future concerns here on the community.
Cheers,
DaneA
NETGEAR Community Team