Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Multiport LAG Across Two GS108T Switches
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-23
09:06 AM
2020-07-23
09:06 AM
I have a 4 port LAG coming from my firewall, down to two GS108T switches. Each switch is connected to the LAG on ports 1 and 2. Port 8 connects each switch to the other. Is this a supported distributed LAG configuration for the GS108T?
Solved! Go to Solution.
Model: GS108Tv2|ProSafe 8 ports gigabit smart switch
Message 1 of 4
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-23
09:15 AM
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-23
09:15 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-23
11:03 AM
2020-07-23
11:03 AM
Re: Multiport LAG Across Two GS108T Switches
Thanks for that info...can the GSM7228PS be stacked using the front gig ports or can I only do this using the stacking modules that go on the back?
Message 3 of 4
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2020-07-23
02:21 PM
2020-07-23
02:21 PM
Re: Multiport LAG Across Two GS108T Switches
Sure, you can use the front 10G ports. Just need to enable stacking mode on these ports (configured mode). Then a reboot of each switch will be needed to have it as running mode. When the first switch is half way booting, connect the cables in between and you can boot the second switch. After both will have booted and discovered each other, your new stack will be formed and ready for distributed link agreegation between the two. You will create your 4-port LAG across both switches, and connect your firewall there.
Hope this helps,
Hope this helps,
Message 4 of 4