- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
NETGEAR ProSAFE GS752TP
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have two NETGEAR ProSAFE GS752TP and i want to stack them. what would i need to stack them
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi brandon16,
You may want to configure LAG on your two GS752TP switches. Kindly access and read the article below for reference:
What are Link Aggregation Groups (LAGs) and how do they work with my managed switch?
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR ProSAFE GS752TP
Hi brandon16,
Welcome to the community! 🙂
Are your switches a GS752TP or GS752TPS? The GS752TP is not stackable while the GS752TPS is stackable.
If ever your switches are GS752TPS, the direct attach cable AGC761 (2.5G) is recommended to be used as a stacking cable and its sold separately. Kindly read page 28 of the hardware installation guide of the GS752TPS here.
About the stacking configuration of the GS752TPS, kindly read page 61-69 of the GS752TPS software administration manual here.
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR ProSAFE GS752TP
Thanks for the fast reply. I should of bought GS752TPS but I bought GS752TP 😞 I will have to figure something out on connecting this two together or might have to have them run independant
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi brandon16,
You may want to configure LAG on your two GS752TP switches. Kindly access and read the article below for reference:
What are Link Aggregation Groups (LAGs) and how do they work with my managed switch?
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR ProSAFE GS752TP
Hi brandon16,
Use the article below as a guide in setting up VLANs and VLAN Routing on your GS752TP:
VLAN Routing on New Smart Switches
Regards,
DaneA
NETGEAR Community Team
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: NETGEAR ProSAFE GS752TP
Hi brandon16,
You're welcome! 🙂
Feel free to post your future concerns here in the community.
Cheers,
DaneA
NETGEAR Community Team