- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Netgear Insight - Denial of Services settings??
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Netgear Insight - Denial of Services settings??
We have lot of switches connected to Insight and its great but on one switch we have a port that keeps disabling itself due to CRC Error packets.
We need this port to stay enabled and from what ive read it is caused by Auto DOS or Denial of Service settings??
I can't see these settings within the insight portal, can anyone help me find them?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Netgear Insight - Denial of Services settings??
Br rule of thumb, the DoS settings are not covered by Insight.
Check if the DoS controls are available on the local WebUI.
In case these are not accessible, you mght have to bring the switch to local management mode, change the DoS config, and re-add to Insight.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Netgear Insight - Denial of Services settings??
Thanks for the fast response, I was hoping to avoid that but if thats my only option i can go and try it.
I wasn't sure if re-adding it to Insight would wipe my changes if it didn't allow it within insight. I'll try visit the site in the next few days and let you know.