- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Permit Internet Traffic on port 443
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Permit Internet Traffic on port 443
Hello,
I have GS716Tv3 ProSafe 16-port Gigabit Ethernet Smart Switch behind my main router. Switch is connected to webserver. I also have my own DDNS and port forwarding rules setup on my main router.
Within internal network (using computer connected to switch), I am able to access webserver over port 443.
However, if I try to access my webserver over the internet, its not getting connected. If I move webserver from switch to main router directly, its working. This makes me sure, that switch is blocking HTTPs over TCP.
I searched in GUI, but couldn't find any option to unblock it. Could some one guide me, on how to unblock this communication. Also, can I see this blockage in some log file.
Many thanks in advance.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Permit Internet Traffic on port 443
Hard to imagine a switch in a default config, no routing, no ACL, no other access limitations should cause such an issue.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Permit Internet Traffic on port 443
What is the current firmware version of the GS716Tv3?
Is the GS716Tv3 directly connected to the main router?
Is your main router a NETGEAR device? If yes, what is the model of it?
Regards,
DaneA
NETGEAR Community Team