Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
S3300-52x won't boot after firmware update 6.6.4.25
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-02-09
08:33 PM
2021-02-09
08:33 PM
S3300-52x won't boot after firmware update 6.6.4.25
Hi,
After performed a firmware update on a stack of 4 S3300-52x, none of them are booting back. It's been 1 hour after the process and I do not know if it's safe to turn them off and back on again.
Any idea?
Help me please...
Model: S3300-52X (GS752TX)|ProSafe 48 ports stackable smart switches
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-02-11
04:16 AM
2021-02-11
04:16 AM
Re: S3300-52x won't boot after firmware update 6.6.4.25
Welcome to the community! 🙂
You may try to turn it off then turn it back on again. Observe the behavior of the LED lights. Then, check if can access the web-GUI of the S3300-52X stack.
If the S3300-52X won't boot up normally, I suggest you to open a support ticket with NETGEAR Support here as soon as possible for further investigation.
Regards,
DaneA
NETGEAR Community Team
Message 2 of 2