Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Stacked Switches access
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-01-30
02:16 PM
2021-01-30
02:16 PM
Stacked Switches access
I have M4300 8x8 and two 52G stacked. I have a local IP address of 10.10.10.x that i cannot access the web interface or ping unless i am physically connected to the 8x8
Any ideas would be greatly appreciated
Stewart
Model: GSM4352S|M4300-52G - Stackable Managed Switch with 48x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3, XSM4316S|M4300-8X8F - Stackable Managed Switch with 16x10G including 8x10GBASE-T and 8xSFP+ Layer 3
Message 1 of 2
Labels:
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2021-03-10
07:52 AM
2021-03-10
07:52 AM
Re: Stacked Switches access
Welcome to the community! 🙂
Are there any changes to your existing network setup or any changes on the settings of the stacked switches?
What is the current firmware of the stacked switches?
It would be best if you post a detailed network diagram so that other community members can post their suggestions to help you.
Regards,
DaneA
NETGEAR Community Team
Message 2 of 2