- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Switch GS728TP: POE Admin enable/disable via SNMP
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Greetings Community,
i need to enable/disable POE on switchpots adimistratively from remote. I cannot use the buit in feature like scheduling, hence i would like to go ahead with snmpset.
What is the correct OID to touch interface X in that manner and the value for on/off?
Which MIB is relevant for this task?
Thanks a lot and best regards!
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tc43,
Welcome to NETGEAR community!
We can use the public MIB POWER-ETHERNET-MIB to control PoE status through SNMP.
Please reference following screenshot to deploy.
May the solution help you.
Thanks,
Daniel.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tc43,
Welcome to NETGEAR community!
We can use the public MIB POWER-ETHERNET-MIB to control PoE status through SNMP.
Please reference following screenshot to deploy.
May the solution help you.
Thanks,
Daniel.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Switch GS728TP: POE Admin enable/disable via SNMP
Hello Daniel,
thanks a lot! I got it running with your hint!
Best regards!
Chris