- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Upgrading firmware on GS105Ev2 -- fails using TFTP
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Upgrading firmware on GS105Ev2 -- fails using TFTP
Greetings,
I have two GS105Ev2 switches that need a firmware upgrade. The current firmware on the switches is 1.3.0.3 and I'm trying to upgrade to 1.6.0.11 downloaded from the Netgear site.
The only option available on the switches is a firmware upgrade via TFTP. To that end, I installed a SolarWinds TFTP server on my troubleshooting laptop (Windows 10). I've also checked the following:
1. The switch management webpage is reachable from the laptop.
2. Both the laptop and the switch are on the same network segment.
3. The TFTP server service is running on the laptop.
4. The laptop Windows Firewall has been configured to allow TFTP traffic (i.e., I've configured the firewall to "allow the TFTP server to communicate").
5. The .bin file is located in the TFTP server root folder.
Even with these checks, when I initiate the firmware upgrade process I receive the error message "Could not locate TFTP server".
Does anyone have any ideas on what else I should check? Is there any other firmware upgrade method for these switches?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgrading firmware on GS105Ev2 -- fails using TFTP
Hello @jcm183,
And welcome to the NETGEAR Community! 🙂
Please call the location of the firmware in the TFTP server and paste it into the GUI of the firmware upgrade box.
If your issue is resolved please close the thread by clicking "Accept as solution".
Have a lovely day,
Anisha A
Netgear Team