Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
XS728T Connection Issues at 10G
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-11-15
02:04 AM
2022-11-15
02:04 AM
XS728T Connection Issues at 10G
Hi, I have two new XS728T switches sat on a bench and am unable to get a 10G Link with a 35M cat6a cable however short cables link at 10G without any problems. I can go into port configuration and change from auto negotiate to 1G full duplex and I will get a successful link which will remain even if I cycle the power to either switch. Occasionally if I go from 1G full duplex back to auto then a 10G link will be established but if I cycle power at that point on either switch I lose the link altogether. Both switches are running the latest firmware
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-11-15
09:12 AM