- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
PLW1000 v2 will no longer connect.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I set up a PLW1000 v2 network to send a WiFi signal to a detatched garage, so I could connect a smart TV. It worked flawlessly for about 2 1/2 months, and then suddenly it will no longer connect. I tried bringing the unit back in the house to see if it was too far away, but still no luck. The TV, my phone, laptop, etc. can all see the network, but when I try to connect it just endlessly loops with "Obtaining IP address". I've even tried connecting my laptop to the WiFi unit with an ethernet cable, but still no luck.
Any advice would be greatly appreciated.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So...it may have been a case of just swithcing the ethernet net port, on the modem, the cable was plugged into. Seems to be working again. I'll update if the problem returns.
DOH!!
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So...it may have been a case of just swithcing the ethernet net port, on the modem, the cable was plugged into. Seems to be working again. I'll update if the problem returns.
DOH!!
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more