× Get free training on Switching for AV over IP and receive AVIXA Credits. Sign up at NETGEAR.academy
Reply

M4250 resetting management port config on power cycle

Pixel_Mike
Follower

M4250 resetting management port config on power cycle

Been attempting to setup and deploy two M4250-12M2XF switches to use in a front of house rack and stage rack. However it seems that whenever the switches lose power, IPV4 management configuration ends up resetting to DHCP. Have attached screenshots of settings before and after a simple power cycle. Is there something I'm missing elsewhere in my configuration?

 

Firmware Version 13.0.4.19

 

Before power-cycle.png

After power-cycle.png

Message 1 of 1
Discussion stats
  • 0 replies
  • 465 views
  • 0 kudos
  • 1 in conversation
Announcements

AV over IP Switches by NETGEAR