- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
stacked M4300-8X8F can't enable fan
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
stacked M4300-8X8F can't enable fan
Hello everyone,
I have two M4300-28G and two M4300-8X8F running in stacked mode. Master is one of the M4300-28G.
The M4300-8X8F were installed a few weeks ago and I noticed that temperature is higher than on the M4300-28G. Upon further investigation i noticed the fans are not running on both of the 8X8F.
I stumpled upon this entry https://community.netgear.com/t5/Managed-Switches/Feature-request-M4300-8X8F-Allow-force-fans-on-qui... and followed these instruction and rebooted the switches.
The fans on the 8X8F are still not running. I connected via powershell SSH to the master switch and the commands were accepted without error (so in the CLI it showed me that the commands were set to M4300-28G but as far as i know the Master stores the configuration for the stacked switches).
Maybe someone has an idea how to enable the fan on the 8X8F?
-
0 replies
-
2023-04-04 02:09 AM
-
989 views
-
0 kudos
-
1 in conversation
-