Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
No access to readycloud
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-08
08:52 AM
2018-03-08
08:52 AM
The serial number is using the MAC address of eth0, how do I change this so that it displays the correct Serial Number so I can connect to ReadyCloud?
Solved! Go to Solution.
Model: RN102|ReadyNAS 100 Series
Message 1 of 6
Labels:
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-10
02:32 AM
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-08
11:48 AM
2018-03-08
11:48 AM
Re: No access to readycloud
On your RN102?
I wouldn’t have expected to see this problem on that having never seen it on that model.
This is an issue seen with a small batch of ReadyNAS Pro units.
I wouldn’t have expected to see this problem on that having never seen it on that model.
This is an issue seen with a small batch of ReadyNAS Pro units.
Message 2 of 6
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-09
02:11 AM
2018-03-09
02:11 AM
Re: No access to readycloud
when I upgraded the firmware the serial shoed as N0NE000200000 - after backing up I did a FACTORY reset and it changed the serial to the MAC address, how do I resolve this. A comment "I wouldn’t have expected to see this problem on that having never seen it on that model" isn't very helpful
Message 3 of 6
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-09
03:21 AM
2018-03-09
03:21 AM
Re: No access to readycloud
Please have a look at the PM I sent earlier today. You should find that more helpful.
I do think this should be straightforward for me to fix. Was just trying to confirm that you selected the correct model in your earlier post.
Message 4 of 6
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-09
12:30 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2018-03-10
02:32 AM