- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Issue with volumes
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Issue with volumes
Recently had power loss in my office and the ReadyNas device all of sudden reported two dead drives. I had numerous things (replacing drives, swapping drives) and now out of sure luck it's reported all 4 drives healthy. However, there is no volume that exists and as I'm finding out there is no backup created.
Is there a way to rebuild the volumes? I'm new to this device so I'm not sure where to start.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Issue with volumes
Unless you were running RAID6 on Flex-RAID, you most likely had a single redundancy volume, RAID5. So two drives gone = your volume is gone. There is a few things that can be attempted, like cloning the "dead" drives if they're not completely dead. Hopefully you didn't make it worse by "moving disks around".
My advice is to contact a data recovery specialist. NETGEAR does provide such service as a contract.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content